Seneca ZC-24DI, 24-Channel Digital Input CANopen/ModBUS Module

Seneca ZC-24DI, 24-CH Digital Input CANopen/ModBUS Module

Price: (4 or fewer items) £195.50 (Excluding VAT at 20%)
Price: (5 to 9 items) £189.50 (Excluding VAT at 20%)
Price: (10 to 24 items) £184.00 (Excluding VAT at 20%)
Price: (25 or more items) £178.50 (Excluding VAT at 20%)

Quantity:

Description:

The ZC-24DI module acquires 24 single-ended digital signals, it converts them to a digital format (IN 1-24 state) and it counts the input-pulse number (pulse counter for IN 1-8).

General Characteristics :

Acquisition of digital signals from sensor: reed, NPN, PNP, proximity, contact, etc...

Configuration of a filter applied to input signals IN1-IN8 (noise filter) to attenuate the noise overlapped to the digital signals

Pulse counters for digital signals IN1-IN8, with max frequency equal to 10kHz, 32bit-registers

Advanced management of the pulse counters for digital signals IN1-IN8 (for each pulse counter: overflow, preset value and reset/preset command are available)

Power of 24 sensors using internal supply voltage (Vaux=16V) ? It is possible to configure the module (node) address and baud-rate by Dip-Switches

It is possible to add/remove the module to/from RS485-bus without disconnecting the communication or power supply

It is possible to switch automatically RS485 to RS232 or vice versa

CAN interface with CANOpen protocol: max 1Mbps

Specification:

Order code :		ZC-24DI
Description:		24 CH digital input CANopen / ModBUS
Power Supply:		10..40 Vdc, 19..28 Vac
Max consumption:		2,5 W
Isolation:		1,5 kVac (3 way)
Response time:		2,5 ms
Operating Temperature:		-10..+65°C
Dimensions:		35 x 100 x 112 mm
Polarity:		EN 61131-2 sink (npn)
Channels:		24
Counters:		8 @ 32 bit (max 10 kHz)
Pulse width:		Min 50 µs
TPDO:		< 1 ms

User configuration will require the S117P1 device (which can be purchased here) and the free EASY-SETUP software (which can be downloaded below).

Please refer to the following documentation for additional information: